There is one prototype of dotc
available, please see below.
dotc( const VectorX& x, const VectorY& y );
dotc
(short for TODO)
provides a C++ interface to BLAS routines CDOTC and ZDOTC.
The selection of the BLAS routine is done during compile-time, and is
determined by the type of values contained in type VectorX
.
The type of values is obtained through the value_type
meta-function typename value_type<VectorX>::type
. Table X below illustrates to
which specific routine this dispatching will take place.
Table 1.10. Dispatching of dotc.
Value type of VectorX |
BLAS routine |
CBLAS routine |
CUBLAS routine |
---|---|---|---|
|
CDOTC |
cblas_cdotc_sub |
cublasCdotc |
|
ZDOTC |
cblas_zdotc_sub |
Unavailable |
The original routines CDOTC and ZDOTC have five arguments, whereas dotc
requires two arguments.
Defined in header boost/numeric/bindings/blas/level1/dotc.hpp
.
Parameters
The definition of term 1
The definition of term 2
The definition of term 3.
Definitions may contain paragraphs.
#include <boost/numeric/bindings/blas/level1/dotc.hpp> using namespace boost::numeric::bindings; blas::dotc( x, y, z );
this will output
[5] 0 1 2 3 4 5